Bike Maintenance.
- CLP
- C grade super domestique
- Posts: 4928
- Joined: Mon Dec 20, 2004 1:37 pm
- Location: Adelaide, South Australia
Re: Bike Maintenance.
So.... i took my MTB in to get a general service and tune up in preparation for the up and coming Outback Odyssey. I have a question for some of the MTBers.
How long (kms) would you expect a chain cassette and chainring to last on a MTB before needing replacement or being deemed "very worn"? For reference, the bike in question is primarily used off road, with some muddy action on occassion, but cleaned pretty much immediately afterwards.....
How long (kms) would you expect a chain cassette and chainring to last on a MTB before needing replacement or being deemed "very worn"? For reference, the bike in question is primarily used off road, with some muddy action on occassion, but cleaned pretty much immediately afterwards.....
- Duke
- Dukester Maldonado
- Posts: 11460
- Joined: Tue Jan 23, 2007 9:33 pm
- Location: Melbourne
Re: Bike Maintenance.
Which end started to break?avro707c wrote:Replaced the cable going to the rear derailleur on the Trek, the other cable had started to have bits of it break off. It seems to be working correctly now.
It's pretty common for the rear derailleur cable to start braking & fraying at the lever end once they get old.
Mis-shifts is usually the tell tale sign to check it.
Dukester
norbs diplomacy lesson 101: "If I was putting words in your mouth, you'd know."
norbs diplomacy lesson 101: "If I was putting words in your mouth, you'd know."
-
- Posts: 881
- Joined: Mon Jan 12, 2009 3:15 am
- Location: Republica.
- Contact:
- wobblysauce
- Seen it, Done it, Invented it!
- Posts: 10489
- Joined: Thu Aug 25, 2005 9:53 am
- Location: On an Island in the south
Re: Bike Maintenance.
Hide it from the Hipsters.
Some play it safe on the merry-go-round, others go for the thrills of the roller-coaster.
ᕙ༼ຈل͜ຈ༽ᕗ vs ლ(ಠ益ಠ)ლ
I have a joke for you. I have a prediction that you are going to walk into a bar, my prediction was wrong and your wallet is gone.
ᕙ༼ຈل͜ຈ༽ᕗ vs ლ(ಠ益ಠ)ლ
I have a joke for you. I have a prediction that you are going to walk into a bar, my prediction was wrong and your wallet is gone.
-
- Posts: 881
- Joined: Mon Jan 12, 2009 3:15 am
- Location: Republica.
- Contact:
Re: Bike Maintenance.
Given that the inside is in a similar state after years of rinsing only, I think they might die shortly after using it ...
-
- Posts: 881
- Joined: Mon Jan 12, 2009 3:15 am
- Location: Republica.
- Contact:
Re: Bike Maintenance.
Some advice on brake pads for a road bike, please? I'm planning to do some proper mountain cycling (starting at 1200m with 600m elevation gain in 12km - with an option on a further 400m in about 4km that may wait for another day - seems to be the craic) soon and pretty sure my current pads aren't really up to the return journey, either in terms of current condition or how alarmingly quickly they wear down ...
- markus
- Posts: 949
- Joined: Sat Dec 18, 2004 7:09 pm
- Location: Gitmo nation reindeer
Re: Bike Maintenance.
No mountains here, but I've been happy with my green and yellow Swisstops.Swain OHaw wrote:Some advice on brake pads for a road bike, please? I'm planning to do some proper mountain cycling (starting at 1200m with 600m elevation gain in 12km - with an option on a further 400m in about 4km that may wait for another day - seems to be the craic) soon and pretty sure my current pads aren't really up to the return journey, either in terms of current condition or how alarmingly quickly they wear down ...
Much cycling such kilometers.
- CLP
- C grade super domestique
- Posts: 4928
- Joined: Mon Dec 20, 2004 1:37 pm
- Location: Adelaide, South Australia
Re: Bike Maintenance.
I use Kool Stop pads. The Salmon pads are meant to be really grippy, but since they are intended for wet weather they can wear quickly. I use the black version. Fairly cheap too other than that, Shimano DuraAce/Ultegra pads are pretty decent and readily availableSwain OHaw wrote:Some advice on brake pads for a road bike, please?
-
- Posts: 881
- Joined: Mon Jan 12, 2009 3:15 am
- Location: Republica.
- Contact:
Re: Bike Maintenance.
My current ones seem to have been cheap ones fitted by the shop when I got my forks done, I should have specified that I wanted new pads that weren't made from Korean newspaper. They wear even quicker in the rain (they basically dissolve) because the first time I used them was my trip around the circular cycle path where the only stops are for road junctions and I wasn't really honking along because it was wet and windy, but I came back with brake dust all over the front of the bike. Again the second time I used them in the dry, but since then they've calmed down a bit, I think - either way, the wear is now sufficient that I wouldn't trust them for a mountain descent ... I'll see if I can track down Kool Stop, and if not Shimano products really ought to be available ...
- CLP
- C grade super domestique
- Posts: 4928
- Joined: Mon Dec 20, 2004 1:37 pm
- Location: Adelaide, South Australia
-
- Posts: 881
- Joined: Mon Jan 12, 2009 3:15 am
- Location: Republica.
- Contact:
Re: Bike Maintenance.
I need Wiggle.es it would seem, but Google did that for me ...
- CLP
- C grade super domestique
- Posts: 4928
- Joined: Mon Dec 20, 2004 1:37 pm
- Location: Adelaide, South Australia
Re: Bike Maintenance.
MTBers .. Anyone running tubeless? would you recommend it? I've had a tubeless kit sitting here for ages and was thinking of putting it on the bike.
- Enforcer-J
- Posts: 6512
- Joined: Wed Oct 12, 2005 11:16 pm
- Location: right on your A.R.S.E.
Re: Bike Maintenance.
Yes. I went legit tubeless (stans rims, UST tyres) and its super quick to install. I havent had a single puncture or issue with it for 2 years. The best thing about tubeless is you can run low pressures and find new levels of grip!CLP wrote:MTBers .. Anyone running tubeless? would you recommend it? I've had a tubeless kit sitting here for ages and was thinking of putting it on the bike.
- Hz-Lab
- Magoo
- Posts: 9898
- Joined: Wed Oct 12, 2005 11:45 pm
- Location: Radelaide
- Contact:
Re: Bike Maintenance.
Yeah I am still yet to do the Tubeless conversion. But not because I have anything against it, purely because running tubes have never been an issue. I have had maybe 3 flats in the last 3 years.. touchwood. What En-J says is correct though, more grip through lower pressures. You do sacrifice a tiny fraction of rolling speed though (if you choose to run lower pressure) but depending on what riding you do, that may not be an issue. If you've got a kit there though try it out.
I am almost due for a new wheelset, When I do that I will be going full tubeless.
I am almost due for a new wheelset, When I do that I will be going full tubeless.
- Enforcer-J
- Posts: 6512
- Joined: Wed Oct 12, 2005 11:16 pm
- Location: right on your A.R.S.E.
Re: Bike Maintenance.
Yeah that's it. Rolling speed isnt really any issue unless you're racing and unless you go big mud tyres they all roll pretty well. Ill run around 27psi in rocky or slippery conditions and around 32 if im on hardpack.Hz-Lab wrote:You do sacrifice a tiny fraction of rolling speed though (if you choose to run lower pressure) but depending on what riding you do, that may not be an issue.
Get some enves kyle?
- Hz-Lab
- Magoo
- Posts: 9898
- Joined: Wed Oct 12, 2005 11:45 pm
- Location: Radelaide
- Contact:
Re: Bike Maintenance.
Nah I won't be going a carbon rim, cos a) ill break them, b) already have 2 mortgages.
Don't really know what I'll get yet lol.
Don't really know what I'll get yet lol.
-
- forum fairy - in a gay way!
- Posts: 5083
- Joined: Thu Jun 30, 2005 7:28 pm
- Location: In a closet
- Contact:
Re: Bike Maintenance.
So my bike has Ultegra 6600 groupset. Can I put an Ultegra 6700 Cassette on?
Is there any difference between these models?
Is there any difference between these models?
- CLP
- C grade super domestique
- Posts: 4928
- Joined: Mon Dec 20, 2004 1:37 pm
- Location: Adelaide, South Australia
Re: Bike Maintenance.
yep, direct swap over.Gizmo wrote:So my bike has Ultegra 6600 groupset. Can I put an Ultegra 6700 Cassette on?
Is there any difference between these models?
i think they're different colours.. not sure if the tooth profile is different to improve shifting. I've been using them for a while on my 6600 ultegra equiped bike and i've had no issues
-
- forum fairy - in a gay way!
- Posts: 5083
- Joined: Thu Jun 30, 2005 7:28 pm
- Location: In a closet
- Contact:
Re: Bike Maintenance.
Sweet. Thanks CLP!
- Jamo
- Posts: 2306
- Joined: Fri Dec 17, 2004 10:55 am
- Location: Sydney
Re: Bike Maintenance.
Maybe stating the obvious but defo swap the chain as well when you do the cassette Giz.
I drink a great deal, I sleep a little and I smoke cigar after cigar. That is why I am in two hundred percent form - Sir Winston Churchill
- norbs
- fucking right wing vegan lesbian
- Posts: 24216
- Joined: Fri Dec 17, 2004 6:01 pm
- Contact:
Re: Bike Maintenance.
Jamo wrote:Maybe stating the obvious but defo swap the chain as well when you do the cassette Giz.
I always do them together, but have read that this in not required if you look after your bike. I will try and dig up the link this arvo. Can't remember if it is chain or cassette which needs to be replaced more often.
Sarc ; my second favourite type of gasm.
-
- forum fairy - in a gay way!
- Posts: 5083
- Joined: Thu Jun 30, 2005 7:28 pm
- Location: In a closet
- Contact:
Re: Bike Maintenance.
I'm doing them both
- markus
- Posts: 949
- Joined: Sat Dec 18, 2004 7:09 pm
- Location: Gitmo nation reindeer
Re: Bike Maintenance.
Chain is cheaper... so if you change the chain before it's worn out you get 2-3x chain vs 1 cassette.norbs wrote:Jamo wrote:Maybe stating the obvious but defo swap the chain as well when you do the cassette Giz.
I always do them together, but have read that this in not required if you look after your bike. I will try and dig up the link this arvo. Can't remember if it is chain or cassette which needs to be replaced more often.
Much cycling such kilometers.
-
- forum fairy - in a gay way!
- Posts: 5083
- Joined: Thu Jun 30, 2005 7:28 pm
- Location: In a closet
- Contact:
Re: Bike Maintenance.
Goodies have arrived
Thankfully nothing is squished.......
Thankfully nothing is squished.......
You do not have the required permissions to view the files attached to this post.
-
- forum fairy - in a gay way!
- Posts: 5083
- Joined: Thu Jun 30, 2005 7:28 pm
- Location: In a closet
- Contact:
Re: Bike Maintenance.
Everything is fitted without any dramas
I must say, i'm super impressed with Wiggle. Order my stuff Thursday night, order arrived Monday morning.
I must say, i'm super impressed with Wiggle. Order my stuff Thursday night, order arrived Monday morning.
You do not have the required permissions to view the files attached to this post.